About Roller Doors Stylish Roller Doors  Stylish Roller Doors use AG77mm laths and are
  designed to be installed in most types of garages
  and business units and anywhere upto a maximum
  width of 5.0m wide x 2.8m high or an area
  approximately 13.4 sq m for class 1 wind load
  resistances according to EN 12424.
 Stylish Roller Doors consist of aluminium foam filled
  profiles usually 77mm and 55mm in height which roll and retract
  into the shutter box located above the lower edge of
  the lintel. The shutter box is normally no more than
  300mm sq and can be installed externally where
  space is limited internally or for low garages there is
  the 55mm profile that rolls into a box of 205mm.
  Stylish Roller Doors can be installed between the
    brickwork openings or fitted inside the rear face
    of the garage wall to give maximum opening width
    between the brickwork faces.
If the internal space above the opening is restricted,
    an external face fix should be considered and this
    will mean that the roller door will be fitted outside the
    garage and will need the full box fitted that
    completely encloses the roller door.
   
    The 77mm standard lath requires at least 300mm
    (1ft) above your opening height to allow for the door
    to roll up into the box above. The lath is 77mm high
    and 19mm thick fully insulated.
 The 55mm lath requires at least 205mm above your
    opening height to allow for the door to roll up into the
    box above. The lath is 55mm high and 14mm thick
    fully insulated.
     Emergency Hand Wind In the event of a power cut, in order to
    enter the garage, there are detachable
    emergency hand winds to open and
    close the doors
  
   Guide Sections The guide sections incorporate
    2 luxurious pile in-fills which
    sandwich the door sections giving
    the door a positive seal helping to
    minimise draughts.
  
   Digi - Box The Digi-Box can be fitted on the
    outside and comes in either black or
    white and is also waterproof which
    enables the door to be opened without
    using the remote control.
  
   Key Switch Doors can be supplied without a
    safety edge kit and control unit and
    be replaced by a key switch
    to keep the cost down.
    An alarm box can also be fitted to the
    door which senses vibrations and
    signals if someone tries to gain
    access to your property.
  
   Safety Edge Kit The rubber seal on the bottom is
    installed to minimise draught, water
    and leaves from being blown
    under the door. Concealed within the rubber seal there is the Safety Edge Kit.
    This is designed to send a light beam
    through the inside of the rubber seal
    which enables the door to stop and
    return if broken.
  
   Auto Lock System An Auto Lock system is a standard
    feature of a motorised shutter which
    provides extra security
  
   
Stylish Roller Doors are installed with a safety brake system to
stop the door from falling if the motor were to fail.
All of our doors are also fitted with a full hood to protect against
any accidents where the finger could be trapped in the roller
and also to make the door aesthetically pleasing on the eye.
*The guides, plates and hoods come in either white, dark brown, black, anthracite grey, rosewood, golden oak.Stylish Roller Doors come complete with a 5 year warranty on the door and motor.
  The control panel and all other electrical components come with 5 years warranty. The safety edge comes with a 2 year warranty. The colour finish has a limited 5 year guarantee.
  All parts come fully CE marked.
  All of our remote controls come with a limited 6 month warranty